1979 - 1981 Trans Am Firebird Tail Light Stud Kit GM (LONG)
FBODYWAREHOUSE CARRIES MORE New and Used replacement tail light parts for your 1979 1980 1981 TransAm and Firebird. Both red lens and smoked lens units!
4 Piece set of the tail light housing to body stud LONG STUD ASSEMBLY
(4) FOR A FULL CAR SET
NOTE: 4 Seperate parts compose ONE assembled long stud.
STUD INCLUDES:
(1) Long Tail Light Housing to Trunk Panel Stud
(1) Trunk Mounted Spin Nut
(1) Trunk Side Seal / Insulater Pad
(1) Exterior Tail Light Housing Seal / Insulator Pad
Reconditioned GM parts see below for details.
Worldwide Shipping Available
Use the drop down menu below
FREE USA SHIPPING
Units mount to the tail light housing and then to the body of the car. This holds the tail light housing tight to the back of the car. General Motors used units in great shape.
All metal studs are chemical dipped to bare metal and reset with a rust preventive clear coat. This gives the studs a deep gray gun metal color. The insulator pads and chemical dipped and soaked to remove most glues and grime. The Spin nuts are chemical dipped to remove drit and debris.
Once the restoration process is done we assemble the unit in a loose fit and bag each individually where it stays just as clean as the day we reconditioned it when you open it up to install Parts are cleaned, prepped, so ZERO work prior to assembly on your tail light!
1979 1980 1981 Trans Am and Firebird models.
EACH TAIL LIGHT USES
3 SHORT STUDS Part # UGM-2-TLS-01
2 LONG STUDS This Item Part # UGM-2-TLS-01-L
(1) BOLT for the fuel door assembly Part # UGM-2-TLS-01-B
FREE SHIPPING inside the USA!